Duracoat 2 Pack Epoxy Enamel is an industrial protective coating from DuraCoat (Basco Products) designed for corrosion protection and priming on steel, iron, and metal surfaces. Supplied by Paints Kenya for contractors, fabricators, and commercial developments across Kenya.
DuraCoat Two Pack Epoxy Enamel is a two component epoxy system highly resistant against abrasion, chemical attack and water penetration
Add to your cart to receive an itemized quotation with project volume discounts and scheduled site delivery across Kenya.
DuraCoat Two Pack Epoxy Enamel is a two component epoxy system highly resistant against abrasion, chemical attack and water penetration
This product is recommended for use on Structural Steel & Iron, Galvanized Sheet Metal, Mild Steel Railings & Gates. It is especially suited for Concrete surface, Metal Surface. For optimum performance and film build, 2 - 3 Coats are recommended.
Paints Kenya supplies genuine Duracoat 2 Pack Epoxy Enamel with direct batch dispatch from Nairobi. We provide contractor pricing, Bill of Quantities (BOQ) cost estimation, eTIMS tax compliance, and turnkey supply-and-apply contracting services nationwide.
Approved surface preparation standards, methodology statements, and target sector deployment protocols.
Heavy-duty industrial anti-corrosive primer systems, red oxide primers, zinc chromate, and aliphatic polyurethane topcoats for steel structures, roofs, and gates.
For new Unpainted Concrete surface, make sure the surface is free from dust, grease, oil and contains no water (moisture). Metal surfaces should be primed with Duracoat 2 Pack Epoxy Primer For previously painted surfaces, Clean the surface and remove loose flakes and sand down to rough surface.
Mix with 3 Parts of Duracoat 2 Pack Epoxy Enamel with 1 Part of HardenerIf required dilute with Duracoat 2 pack epoxy thinner
Our application crews handle diamond grinding, surface moisture testing, and multi-coat installation adhering strictly to manufacturer technical data sheets.
Duracoat 2 Pack Epoxy Enamel is formulated for application on Structural Steel & Iron, Galvanized Sheet Metal, Mild Steel Railings & Gates. Manufacturer recommendations specifically highlight Concrete surface, Metal Surface.
According to DuraCoat technical specifications, the theoretical spread rate is 12 - 13 Sq. Mt/Ltr. Actual coverage on site depends on surface porosity, plaster texture, substrate absorption, and application method.
Duracoat 2 Pack Epoxy Enamel is touch-dry in approximately 3 - 4 Hours. Allow at least 24 Hours - 30 Hours between successive coats under standard atmospheric conditions (25°C and 50% relative humidity).
For new Unpainted Concrete surface, make sure the surface is free from dust, grease, oil and contains no water (moisture). Metal surfaces should be primed with Duracoat 2 Pack Epoxy Primer For previously painted surfaces, Clean the surface and remove loose flakes and sand down to rough surface.
Application can be carried out using Brush, Roller, Spray. Manufacturer thinning guidance specifies: Mix with 3 Parts of Duracoat 2 Pack Epoxy Enamel with 1 Part of HardenerIf required dilute with Duracoat 2 pack epoxy thinner.
You can purchase genuine Duracoat 2 Pack Epoxy Enamel directly through Paints Kenya. We supply contractors, institutions, and residential clients with competitive trade pricing, computerized colour tinting, official KRA eTIMS invoices, and site delivery within Nairobi and nationwide.
